Tema: Vento Etapa NAD C270 y previo Yamaha DSP-E492 (VENDIDO)

Muy buenas se vende lo siguiente, todo en perfecto estado, o cambiar por un receptor AV.

* ETAPA NAD C 270 .- VENDIDO



En este enlace se pueden descargar las especificaciones y el manual.

http://nadelectronics.com/products/h...ower-Amplifier

SPECIFICATIONS
Power Amp Section
Continuous Average Power Output into 8 Ω 120W (20.8dBW)
(Min. power per channel, 20Hz - 20kHz both channels driven with no more than rated distortion)
Rated distortion (THD 20Hz-20kHz) 0.03%
Clipping power (max. continuous power per channel) 140W (21.5dBW)
IHF dynamic headroom at 8 Ω 2.4dB
IHF dynamic power 8 Ω 210W (23.2dBW)
4 Ω 340W (25.3dBW)
2 Ω 450W (26.5dBW)
Damping factor ref. 8 Ω 50Hz >150
Frequency response 20Hz-20kHz +/-0.3dB
3Hz/70kHz -3dB
Input impedance R and C 20kΩ / 300pF
Input sensitivity ref. rated power 1.1V
Voltage gain x 28.3 (29dB)
Signal/noise ratio A weighted; ref. 1W >100dB
A weighted; ref. rated power >120dB
Bridged (Monophonic) Mode
Continuous Average Power Output into 8 Ω 300W (24.8dBW)
(20Hz - 20kHz both channels driven with no more than rated distortion)
IHF dynamic headroom at 8 Ω 2.2dB
IHF dynamic power 8 Ω 600W (27dBW)
IHF dynamic power 4 Ω 800W (28.5dBW)
Physical Specifications
Dimensions (W x H x D) 17 1/8 x 5 3/16 x 13 13/16"
(435 x 132 x 350mm)
Net weight 24.8 lbs (11.2kg)
Shipping weight 31.3 lbs (14.2kg)

* PREVIO PROCESADOR YAMAHA DSP-E492.- VENDIDO



http://usa.yamaha.com/products/audio...92/?mode=model

SPECIFICATIONS
Power, Min. RMS Output power/ch., 8 ohms Center: 20 Hz - 20 kHz, 0.04% THD = 60 W Rear Effects Ch: 20 Hz - 20 kHz, 0.04% THD = 60 W
Dynamic Power per Channel 8/6/4/2 ohms = 115/140/160/175 W
Damping Factor 20 Hz - 20 kHz, 8 ohms = 200
Frequency Response 20 Hz - 20 kHz = +/-0.5 dB (Pre-Out)
Total Harmonic Distortion (20 Hz - 20 kHz) Pre-Out = 0.006%
Signal-to-Noise Ratio, IHF-A Network Pre-Out = 96 dB
Dimensions (W x H x D) (435 * 126 * 390mm) (17-1/8 * 5 * 15-15/16)
Weight 8.5 kg / 18.7 lbs.

Un saludo.

RAFA